£39.60
Use this cable to connect a Skylla-i to a VE.Bus BMS. The VE.Bus BMS will then disable the Skylla-i charger when the batteries are fully charged. This cable is intended for on/off control of the Skylla-i when the source signal is high when the Skylla-i must be on, and low or free floating when Skylla-i must be off.
Out of stock
Use this cable to connect a Skylla-i to a VE.Bus BMS. The VE.Bus BMS will then disable the Skylla-i charger when the batteries are fully charged. This cable is intended for on/off control of the Skylla-i when the source signal is high when the Skylla-i must be on, and low or free floating when Skylla-i must be off.
| Weight | 0.020000 kg |
|---|---|
| Dimensions | 23 × 21 × 1 cm |
Features include: Temperature sensor, use as a power supply, forced cooling, Remote on-off port (can be connected to a Li-Ion BMS), Synchronised parallel operation with VE.Can.
Input voltage / input voltage range: 230 V AC / 185-265 V AC.
Maximum AC input current @ 180 VAC: 16 A.
Frequency: 45-65 Hz / Power factor: 0.98.
Charge …
The Skylla-i Control allows you to alter the charge current and see the system status.
A modern and powerful battery charger that withstands the rigors of an adverse environment: heat, humidity and salt air.
Skylla-i (1+1): two isolated outputs to charge 2 battery banks. The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to top up a starter battery.
Rugged – Aluminium epoxy powder coated cases with drip shield and stainless steel fixings withstand the rigors of an adverse environment: heat, humidity …
Temperature sensor for BMV-702 or BMV-712 battery monitor. This product will only work with a BMV-702 or BMV-712 battery monitor.
Similarly to diode battery isolators, FET isolators allow simultaneous charging of two or more batteries from one alternator (or a single output battery charger), without connecting the batteries together. Discharging the accessory battery for example will not result in also discharging the starter battery.
In contrast with diode battery isolators, FET isolators have virtually no voltage loss. Voltage drop …
Used to connect the BMV-600 series Battery Monitors to VE.Direct Enabled controllers