Maretron Temperature Module

£295.20

Six External Temperature Probes are Measured and Broadcast Over NMEA 2000 Network.

Four Channels for Thermistor Probes and 2 Channels for High Temperature Thermocouple Probes.

Wide Variety of Applications Supported with Optional Temperature Probes.

4 in stock

SKU: 468-TMP100-01 Category:

Description

TMP100 – Temperature Monitor.

Maretron’s TMP100 measures the temperature for up to 6 temperature probes and reports the information over an NMEA 2000 network. The TMP100 supports up to 4 thermistor probes and 2 high temperature thermocouple probes. Optional thermistor probes (-20°C to 80°C or -4°F to 176°F) cover a wide range of applications including cabin air temperature, engine room air temperature, refrigerator/freezer temperature, under bolt temperature (inverters, charges, pumps, motors, etc.), tank temperatures (live well bait, hot water, etc.), and air duct temperatures. The optional thermocouple probes (0°C to 900°C or 32° to 1652°F) are used to measure Exhaust Gas Temperature (EGT) as part of a comprehensive fuel management system. Best of all, the TMP100 is NMEA 2000® certified so you can view any and all temperature information anywhere on the vessel using a compatible NMEA 2000® display. The TMP100 is a key component of Maretron’s N2KView® vessel monitoring and control system.

Additional information

Weight0.570000 kg
Dimensions25 × 18 × 11 cm

You may also like…

  • Maretron

    Maretron Fuel Flow Monitor

    FFM100 converts a variety of flow senders (e.g., fuel, water, etc.) to NMEA 2000® Network Data.

    All flow senders ordered separately depending on application (i.e., single fuel flow sender for gas engine, dual fuel flow senders for diesel engine, water flow sender for sea water, etc.).

    Fuel flow senders facilitates fuel consumption optimization for reduced fuel operating cost.

    …

    £392.40

  • Maretron

    Maretron Switch Indicator Module

    Monitors and reports the running statuses of six independently connected devices.

    Can detect and report problems like opens and shorts in switch circuits.

    £392.40

  • Maretron

    Maretron Solid-State Rate/Gyro Compass

    Maretron’s SSC300, implementing the second generation of Maretron’s award-wining compass technology, is a solid state, rate gyro electronic compass that provides better than 0.7° heading accuracy through ±45° of roll and pitch angle, and better than 1° roll and pitch accuracy in static conditions.

    £595.20

  • Maretron

    Maretron Fluid Pressure Monitor

    Adapts up to six pressure transducers to the NMEA 2000® network.

    Each channel independently programmed to match pressure transducer characteristics.

    Each channel independently programmed in pressure/vacuum mode or tank level mode.

    In Tank Level Mode, measures levels of extremely deep or irregularly shaped tanks.

    £392.40

Related products

  • Maretron

    Maretron Micro Termination Resistor Male

    Screw connector for positive connection .

    Termination resistors are used to terminate both ends of the trunk line.

    £10.80

  • Maretron

    Maretron Tank Level Monitor 40”Depth Tanks

    Maretron’s TLM100 is used to sense fluid levels of tanks by using ultrasonic technology. Ultrasonic, or sound waves, are transmitted via the TLM100 mounted at the top of the tank and the flight times of the sound waves to and from the fluid are measured much like a depth sensor. What this means for you is that there are no …

    £226.20

  • Maretron

    Maretron Gateway NMEA2000 USB

    Maretron’s USB100 is a gateway for bridging computers to an NMEA network. This allows you to use PC based vessel monitoring and control software like Maretron’s N2KView® or PC based navigation software. The gateway provides one simple connection between the network and the PC, which eliminates conventional multiplexers and the maze of wires usually associated with interfacing equipment to PCs. 

    £208.30

  • Maretron

    Maretron Micro Termination Resistor Female

    Screw connector for positive connection .

    Termination resistors are used to terminate both ends of the trunk line.

    £10.80